- SINUMERIK Service Assistance
- Introduction
- Safety notes
- Product overview
- Machine Configuration in MindSphere
- Aspect configuration for SSA with MMM
- Aspect configuration for SSA with BFC Gateway
- Module description
- Troubleshooting
- Appendix
- Glossary
- Introduction
- Safety notes
- Product overview
- Machine Configuration in MindSphere
- Aspect configuration for SSA with MMM
- Aspect configuration for SSA with BFC Gateway
- Module description
- Troubleshooting
- Appendix
- Glossary
Overview
The following describes how to configure the required aspects so that SSA can successfully capture and process the machine data. Here is an example of the procedure described. Details of the configuration are listed in Data Acquisition in MMM - "Time-based / cyclic trigger" and Data Acquisition in MMM - "Variable value-based trigger".
The following aspects must be configured via MMM, as "Time-based / cyclic trigger":
-
SINUMERIK_CSRAW
-
CSM_General_Info
The following aspects for the Axes and Spindles must be configured via MMM, as "Time-based / cyclic trigger":
-
CSM_AX01, CSM_AX02, ... (depending on the number of axes)
-
CSM_SP01, ... (depending on the number of spindles)
The following aspects must be configured via MMM, as "Variable value-based trigger":
-
SINUMERIK_CSALARMREACTION
NOTE
For assets created from type "basicsinumerikasset", shoopfloor aspect configuration will be automated with activation. For more detailed information, see chapter Machine model and auto aspect creation and configuration.