Results
- SINUMERIK Service Assistance
- Introduction
- Safety notes
- Product overview
- Machine Configuration in MindSphere
- Aspect configuration for SSA with MMM
- Aspect configuration for SSA with BFC Gateway
- Module description
- Troubleshooting
- Appendix
- Glossary
- Introduction
- Safety notes
- Product overview
- Machine Configuration in MindSphere
- Aspect configuration for SSA with MMM
- Aspect configuration for SSA with BFC Gateway
- Module description
- Troubleshooting
- Appendix
- Glossary
Clarification of machine variable parameters
In chapter Data Acquisition in MMM - "Time-based / cyclic trigger" the variables for the aspect configuration are listed. There are specific variables assigned to the controller like "param", "slave number", "drive number", "io system nr". These variables are coded in parameter numbers, i.e. "35,3,4". This example describes how these variables are observed and determined.
Variable and parameter numbers
The following screen in SINUMERIK Operate shows the connection between variables and parameter numbers:
Chap. A.5