Results
Configuring aspect for "time-based / cyclic trigger" acquisition
Procedure
In the following, you can find an example how to configure the Aspect "SINUMERIK_CSRAW":
-
Load "Shopfloor Management Application".
-
Select your previously created Asset.
-
Press "Advanced".
-
Press "Add".
-
Select "Time-based / cyclic trigger (Variables)".
-
Type the Aspect name and select "Reading cycle" from the drop-down menu.
-
Press "Add" as many times as necessary to add the number of needed variables.
-
Type the "Name", "Address", "Datatype" and "Unit" of the variable to be added.
-
Press "Save".
-
Wait until the response of the successful saving and press "OK".
-
Verify that the Aspect was created as expected.
-
This procedure should be repeated until all the needed "Time-based / cyclic trigger" Aspects are created. For example:
NOTE
If SSA toggles are enabled before MMM activation, you have to manually configure the assets . For manual asset aspect configruation, this section needs to be followed.