Overview
Requirement
-
Windows 7 SP1
-
The up-to-date Windows patches must be installed
-
.NET Framework as of 4.x must be installed
-
MicrosoftEasyFix51044 must be installed so that TLS 1.2 functions
You can find more information on MicrosoftEasyFix51044 at: Microsoft support
The direct download link is: Download microsoftEasyFix51044
-
Visual C++ (free software for Visual Studio 2015 or higher) must be installed
-
SINUMERIK Integrate Client version 4.12.0.21
-
To establish a connection to MindSphere, TLS 1.2 Support must be activated.
Further information about MindSphere can be found in the
Installation Manual SINUMERIK Integrate MMP, MMT, AMC, AMP, AMM/E, AMD.
Introduction
In order to use ManageMyMachines with FANUC control systems, you must carry out the following installations and configurations:
-
Install the SINUMERIK Integrate/ePS Client
Information on SINUMERIK Integrate/ePS Client can be found at: Installing the SINUMERIK Integrate client -
Install the FanucModule
You can find information on installation at: Installation with the 3rdPartyController -
Integrate the FanucModule in the SINUMERIK Integrate/ePS client
You can find information on integration at: Replace the current driver with the Fanuc driver -
Integrate MTConnect in the SINUMERIK Integrate/ePS client
Information on integration can be found at: Replace the current driver with the MTConnect driver -
Configure the FanucModule and MindSphere
You can find information on configuration at: Configuring FanucModule and MindSphere -
Configure the FanucModule and MindSphere
Information on configuration can be found at: Configuring MTConnect and MindSphere -
Configure customized settings in MindSphere
Information about the configuration can be found at: Integrating variables
If you no longer wish to use the 3rdPartyController, then uninstall the software
Information on the uninstallation can be found at: Uninstalling 3rdPartyController
NOTE
The file upload is not currently supported on Fanuc controls because of the lack of drivers.