Protection Devices Dashboard

You can monitor the below mentioned parameters in this tab:

• Breaker information: Displays the state of the breaker with below mentioned representations:
  Breaker position ((for breakers with draw-out frame): Not present, Disconnected, Operational
  Breaker state: OFF (open), ON (Closed), Tripped, Init
  Available messages: Warning messages (Yes/No), Tripping messages (Yes/no)
  This field is updated at every event change.

• Maximum Phase current: Displays the phase current with maximum load out among phases L1/L2/L3. Drawing of the Overload current Ir is indicated when the donut is 75% complete. If the maximum phase current exceeds the overload limit, the donut changes to red. This field is updated for every 10sec interval.

• Health Indicator: Displays the health of the breaker for devices that support condition monitoring. This is currently supported only for 3VA breakers with firmware V4.4 or later.

• Remaining Lifetime: Displays the Remaining lifetime of the breaker for devices which support condition monitoring. This is currently supported only for 3VA breakers with firmware V4.4 or later.

• Active Power: Displays Active power for L1/L2/L3. This field is updated for every 10sec interval.

• Reactive Power: Displays Reactive power for L1/L2/L3. This field is updated for every 10sec interval.

• Apparent Power: Displays apparent power for L1/L2/L3. This field is updated for every 10sec interval.

• Instantaneous Values: Displays the instantaneous line current values

• Energy Values: Displays Active energy import, Active energy export, Reactive energy import and Reactive energy export. This field is updated for every 15 minute interval.

This tab displays the breaker statistics.

This tab displays the device identification details.