User interface "Data Source SIPLUS SM1281"

Within the "Data Source SIPLUS SM 1281" tab you configure the data source of a SIPLUS SM1281 device.

The following graphic shows the different areas of the "Data Source SIPLUS SM1281" window:

131512250763.png

Save or cancel

Device Type

General

Settings

Data

Characteristics

Parameter table SIPLUS SM 1281

The following table shows the individual areas and parameters of the "Devices" window:

Area

Parameter

Description

Device type

-

Shows from which device type the configuration is created.

General

Device Name

Add an individual name for your device.

Description

Add an individual description (optional).

Settings

IP

Add the IP address of the device.

Command Port

Add the command port of the device.

Data Port

Add the data port of the device.

Data

Enabled

Put a tick in the box to activate the channel.

Reference

Displays the source which provides this data.

Unit

Shows the unit in which the value is given.

Data Name

Field to add an individual signal name. Subsequent the individual signal name is put together with the Data Name Prefix to create clear terms.

Sample Rate

Select the preferred sample rate.

Sensor Sensibility [mV/g]

Add a value for the sensor sensibility.

Characteristics

RMS Acceleration

Enable or disable the streaming of a pre-calculated RMS Acceleration. The RMS Acceleration is an indicator about the energy contained in the higher frequency range of the component.

RMS Velocity

Enable or disable the streaming of a pre-calculated RMS Velocity. The RMS Velocity is an indicator about the energy contained in the lower frequency range of the component.

Diagnostics

Enable or disable the streaming of a pre-calculated DKW. The DKW is an indicator for bearing damages