Browsing datapoint of a data source

After adding the data source, you can browse the datapoints for the selected data source.

NOTE

  • This feature is only supported for S7+, IEC61850 and MTConnect protocols.

  • During configuration of data points via browsing feature, performance may get impacted depending on the configuration and data points in Data Sources.

Prerequisite

  • You have created a data source.

  • After creating the data source, click "Save" and "Apply changes".

Procedure

To browse the datapoints of a data source, follow these steps:

  1. Click "Enter Edit Mode" and select the datasource.

  2. Click 157724734347.png to browse the datapoints of the data source.

  3. Select the required data points.

  4. Click "Save" and then click "Apply changes".

Result

The available datapoints are displayed for the selected data source.

157720395147.png

Check and uncheck to select the datapoints of a data source

List of the datapoints of the selected data source

Re-loads the datapoints forcefully

Displays the last retrieval of the datapoints

Note:

The retrieved datapoints of a selected data source is available only for 24hrs.

Displays the number of selected datapoints