Skip to content

Entering values of a parameter

From the parameter list, the current values of a variable are shown.

The enter data functionality can be used in the case of missing values or if modification of a certain variable or datapoints is needed, it is not possible to automatically collect and fill out the necessary data.

Entering of data is supported in case the parameter is a variable and the mode is set to Raw values.

Procedure

To display the current values of a parameter, proceed as follows:

  1. Show the parameter list.
  2. Click 175158468107-d2e3150 for the selected parameter.
  3. Select Detail in the drop-down menu.
    The preview of the current values is displayed.
    161153642635-d2e3161
  4. To display a different period, use the navigation elements.
  5. To enter data for the selected variable, click Adjust values in the action menu.
  6. Click Enter data to open up the enter data table view.
    enter-data-blank
  7. There a two options to enter data:
    1. Adding single values
      "Add single values" is used in case you would like to enter data based on your specific timestamps.
      enter-single-data
    2. Configure calculation cycle
      "Configure calculation cycle"is used in case cyclic data shall be entered.
      A calculation cycle and a time range can be selected and the table will be prefilled according to the settings used.
      This can enhance use cases, such as "Entering weekly data on daily basis".
      enter-cyclic-data

Except where otherwise noted, content on this site is licensed under the Siemens Inner Source License .