Skip to content

User interface "Data Source SIPLUS SM1281"

Within the "Data Source SIPLUS SM 1281" tab you configure the data source of a SIPLUS SM1281 device.

The following graphic shows the different areas of the "Data Source SIPLUS SM1281" window:

SM1281

① Save or cancel

② Device Type

③ General

④ Settings

⑤ Data

⑥ Characteristics

Parameter table SIPLUS SM 1281

The following table shows the individual areas and parameters of the "Devices" window:

Area Parameter Description
Device type - Shows from which device type the configuration is created.
General Device Name Add an individual name for your device.
Description Add an individual description (optional).
Settings IP Add the IP address of the device.
Command Port Add the command port of the device.
Data Port Add the data port of the device.
Data Enabled Put a tick in the box to activate the channel.
Reference Displays the source which provides this data.
Unit Shows the unit in which the value is given.
Data Name Field to add an individual signal name. Subsequent the individual signal name is put together with the Data Name Prefix to create clear terms.
Sample Rate Select the preferred sample rate.
Sensor Sensibility [mV/g] Add a value for the sensor sensibility.
Characteristics RMS Acceleration Enable or disable the streaming of a pre-calculated RMS Acceleration. The RMS Acceleration is an indicator about the energy contained in the higher frequency range of the component.
RMS Velocity Enable or disable the streaming of a pre-calculated RMS Velocity. The RMS Velocity is an indicator about the energy contained in the lower frequency range of the component.
Diagnostics Enable or disable the streaming of a pre-calculated DKW. The DKW is an indicator for bearing damages

Any questions left?

Ask the community


Except where otherwise noted, content on this site is licensed under the MindSphere Development License Agreement.


Last update: April 20, 2022